This is in regards to the Leica Geosystems Flexline instrument
This includes the models below from Leica:
TS02, TS06, and TS09
Set it to the "CR_LF" option {don't use just "CR"}
***On the TS02 to access the settings in the instrument:***
1) From the Main Menu select "Settings"
2) From the Settings Menu select "Comm"
3) For using a 9pin instrument cable change the Port to "RS232"
--> Please Note: to use Bluetooth set Port to "Bluetooth" and use a pin of "0000"
4) Set the defaults as shown below:
1. Baud --> 19200
2. Databits --> 8
3. Parity --> None
4. Endmrk --> CR/LF {if its on CR hit Arrow Right ->}
5. Stopbits --> 1
5) After filling out all the settings tap F4 for "OK"
6) hit ESC to return to the Measure screen
***In SurvCE 2.61 or higher:***
1) Go into Equip / Total Station
2) Set the Manufacturer to "Leica TPS Series (Direct)"
3) Set the Model to "TS0x"
4) Tap the Comms tab and set it up for:
Type: Cable
Port: Com1
Baud: 19200 / Data Bits: 8 / Parity: None
5) Tap the "Settings" tab and select your FS Target and BS Target prism options
6) Tap the Green Check in the upper right to save your Changes