Leica TPS TCRA1101, 1103, 1105 (Robotic)
Leica - Communication Settings (19200,8,None,1)
***On the Leica 1100 instrument***
1. Turn on the instrument
2. Level the instrument
3. From the main menu select menu item 5 - "Configuration"
4. Select menu item 2 - "Communication mode"
5. Select menu item 2 - "GeoCOM parameters"
6. Highlight "Baudrate" and press the enter key "↵"
7. Highlight "19200" and press the enter key "↵" to accept
8. Verify that the "Protocol" is "GeoCOM"
9. Highlight "Parity" and press the enter key "↵"
10. Highlight "None" and press the enter key "↵" to accept
11. Verify the "Terminator" is "CR LF"
12. Highlight "Data Bits" and press the enter key "↵"
13. Highlight "8" and press the enter key "↵" to accept
14. Verify "Stop Bit" is 1
15. Select F1 - Soft key "CONT" to set parameters
16. Select menu item 3 - "GeoCOM On-Line mode"
17. At the prompt "Do you want to switch?", select F4 - Soft key "YES"
***In SurvCE 2.58 or higher***
1) Equip / Total Station
2) Set the Manufacturer to "Leica Robotic Total Station"
3) Set the Model to "TPS 1100"
4) Tap the Comms tab and set it to Type: Radio and Radio: "Leica 1100 Remote"
5) Com3 / Baud: 19200 / Data Bits: 8 / Parity: None
6) Tap the "Settings" tab and select your FS Target and BS Target prism options
7) Tap the Green Check in the upper right to save your Changes