This is in regards to using the Leica Geosystems TPS 700
This includes the models below from Leica:
TC702,TC702A,TC703,TC703A,TC705,TCR702,TCR703,TCR705
Set it to the "CR_LF" option {don't use just "CR"}
***On the TC700 to access the settings in the instrument:***
1) Tap the SHIFT key then tap PROG
2) Tap "3" for ALL SETTINGS
3) Tap "4" for PC COMMUNICATIONS
4) Set the defaults as shown below:
1. Baud --> 19200
2. Databits --> 8
3. Parity --> None
4. Endmrk --> CR/LF {if its on CR hit Arrow Right ->}
5. Stopbits --> 1
5) After filling out all the settings tap SET
6) hit ESC to return to the Measure screen
***In SurvCE 2.58 or higher:***
1) Go into Equip / Total Station
2) Set the Manufacturer to "Leica TPS Series (Direct)"
3) Set the Model to "TPS 700/700 Auto"
4) Tap the Comms tab and set it up for:
Type: Cable
Port: Com1
Baud: 19200 / Data Bits: 8 / Parity: None
5) Tap the "Settings" tab and select your FS Target and BS Target prism options
6) Tap the Green Check in the upper right to save your Changes