Leica TPS 1100 Series:
· TC1101, TC1102, TC1103, TC1105
· TCR1101, TCR1102, TCR1103, TCR1105
· TCM1101, TCM1102, TCM1103, TCM1105
· TCRM1101, TCRM1102, TCRM1103, TCRM1105
· TCA1101, TCA1102, TCA1103, TCA1105
· TCRA1101, TCRA1102, TCRA1103, TCRA1105
Leica TPS TCRA1101, 1103, 1105 (Direct)
Leica - Communication Settings (19200,8,None,1)
***On the Leica 1100 instrument:***
1. Turn on the instrument
2. Level the instrument
3. From the main menu select menu item 5 - “Configuration”
4. Select menu item 2 - “Communication mode”
5. Select menu item 1 - “GSI parameters”
6. Highlight “Baudrate” and press the enter key “↵”
7. Highlight “19200” and press the enter key “↵” to accept
8. Verify that the “Protocol” is “GSI”
9. Highlight “Parity” and press the enter key “↵”
10. Highlight “None” and press the enter key “↵” to accept
11. Verify the “Terminator” is “CR LF”
12. Highlight “Data Bits” and press the enter key “↵”
13. Highlight “8” and press the enter key “↵” to accept
14. Verify “Stop Bit” is 1
15. Select F1 - Soft key “CONT” to set parameters
16. Select F1 - Soft key “BACK”
17. Select F1 - Soft key “BACK”
18. Select F6 - Soft Key “MEAS”
***In SurvCE 2.58 or higher***
1) Equip / Total Station
2) Set the Manufacturer to "Leica TPS Series (Direct)"
3) Set the Model to "TPS 1100"
4) Tap the Comms tab and set it up for:
Type: Cable
Port: Com1
Baud: 19200 / Data Bits: 8 / Parity: None
5) Tap the "Settings" tab and select your FS Target and BS Target prism options
6) Tap the Green Check in the upper right to save your Changes