Category: SurvCE|PC / SurvCE / Quick Start Guides / Carlson Instruments | ||
Topic ID: 980 | ||
Title: Carlson BRx5 - Internal GSM modem | ||
| ||
This is in regards to using the Carlson BRx5 as a network rover with the Internal GSM modem. !!! Please Note: On Dec. 31st, 2016, AT&T ceased providing 2G service on the AT&T cell network. Because of this shutdown, the internal cell modem in the Carlson BRx5 GNSS receiver no longer works on the AT&T cell network. You can click the link below for a detailed description of the alternatives to using the AT&T sim chip: Carlson_BRx5_ATT 2G Shutdown.pdf Here is the steps you can use to setup the Internal GSM modem with T-mobile: 1) Insert your T-mobile sim chip into the BRx5 and power the unit on 2) Go into Equip / GPS Rover and set it for Manufacturer: Carlson and Model: BRx5 3) Tap the Comms tab and set it for Type: Bluetooth and BT Type: Windows Mobile then tap the "wrenches" next to Windows Mobile and use the "Find Device" button to add your BRx5 4) Tap the Bluetooth Plug icon in the top middle to connect to your BRx5 by bluetooth 5) Then tap the RTK tab and change it to Device: Internal GSM and tap the "wrenches" off to the right 6) Set the "Provider" for T-Mobile then tap the Green Check to use the most default T-mobile APN settings 7) Set it to Network: NTRIP then tap the "wrenches" icon next to Network: NTRIP. 8) Tap "NtripInfoCasters" or whatever Base Network is shown in the top left and tap | ||
| ||
| ||
|