This is in regards to installing SurvCE Version 4.07.6 into a Leica Viva CS15 landscape data collector if you don't have
access to the USB cable for connecting to your computer.
***PLEASE NOTE: You cannot Register SurvCE 4.0 using an older SurvCE 2.0 or 3.0 serial number
All of the newer versions of SurvCE Version 4.0 and higher require a SurvCE 4.0 serial number upgrade and a new
registration using the SurvCE 4.0 registration page at the link below:
SurvCE 4.0 Registration
Please follow the steps below to install SurvCE using an SD card:
1) Right-click on the link below click "Save As" or "Save Target As" to save this file as all one piece {1 file} to your
Desktop:
SurvCE_4076_Viva_Landscape.arm.CAB
2) After the download is complete = copy this single file "SurvCE_Viva_Landscape.arm.CAB" from your Computer onto a
Secure Digital flash memory "SD Card" or USB thumb drive.
3) Insert the Secure Digital flash memory "SD Card" into the Viva CS15 in the slot under the black rubber cover on top
of the data collector by turning the screws to remove it or plug the USB thumb drive into the bottom of the unit.
4) Power on the Viva CS15 and exit out of SurvCE or SmartWorx to get to the Windows CE screen
5) Double-tap "My Device"/ double-tap "SD Card" or "USB drive" double-tap the SurvCE.CAB file we copied in Step #2
6) If you are prompted to Re-Install tap "YES".
7) Tap OK in the Upper right when it gives you a choice where to install it {DO NOT Select any folders or change
anything when prompted for a folder = only tap OK}
8) After the Status Bar finishes you can tap "X" in the upper right to close the File Explorer.
9) Now you can double-tap the SurvCE Icon then tap Continue Last Job and tap Equip / then tap About SurvCE to see the
Version and check to make sure it has been updated properly
10) If this is your first time running SurvCE 4.0 you will need to register it using the link below:
SurvCE 4.0 Registration