This is in regards to using a Sokkia SX, and IX, Series Robot with SurvCE Version 3.0 or higher.
Sokkia Settings
Power on the Sokkia SX instrument and Level the instrument
From the main screen tap the "CONFIG" button or you can press the "SETTINGS" button on the keypad
Tap on "5. Comms" under the Configuration tab
In the Comms Setup tab:
Set Comms mode to "Bluetooth"
Set the Checksum to "NO"
Set Controller to "2way + Remote"
Set Xon/Xoff to "Yes"
Tap the RS232C tab and set the Baud Rate to "9600 bps"
Tap the OK button to save your changes
Tap the BACK button to return to the Main Menu
SurvCE Settings
On your data collector open up SurvCE
Tap the Equip tab then tap "Total Station"
Set the Manufacturer to "Sokkia Robotic" and the Model to "SX"
Tap the Comms tab and set the Type: to Bluetooth
Set the "BT Type:" to Windows Mobile
PLEASE NOTE: Depending on the model of data collector you are using you may need to select Socket, Atinav or Microsoft
Power on your RC-5 unit
Tap the wrenches icon next to "BT Type: Windows Mobile"
Tap the "Find Receiver" button to search for your RC-5 unit
Select your RC unit from the list and tap the Green Check
Tap the Bluetooth Plug icon in the upper right to connect
Fill out the "Settings" tab with the appropriate FS Target foresight prism and BS target backsight prism options
Fill out the "Inst" tab with the options you want to use
In the "Search" tab when using the RC unit make sure to set the "A.T. Setting" option to "Track". (using "Search" could cause 30 second delays when locking onto the prism and should only be set when your not using the RC unit)