Draw 3DPoly Base Breakline
Function
This command draws a 3D polyline in the BASE_BREAKLINE layer. This
polyline is used by
the Calculate Stockpile Volume and Calculate Pond/Pit
Volume routines to model the base surface. You may want to set your
AutoCAD Object Snap prior to running this routine so that you
obtain the elevations of existing points while creating the 3D
polyline.
Prompts
Select the 3Dpolyline options you want and press enter.
command: 3DBASE
[Continue/Extend/Follow/Options/<Pick
point or point numbers>]: (Pick)
Interpolate/screen
Pick/<Elevation> <0.00>: 818
Z: 818.00
[Arc/Close/Direction/Follow/Undo/<Pick
point or point numbers>]: (Pick)
Slope/Ratio/Interpolate/Degree/screen
Pick/<Elevation> <0.00>: 814
Z: 814.00, Hz dist: 60.64, Slope dist:
60.77, Slope: -6.6% Ratio: -15.2:1
[Arc/Close/Direction/Extend/Follow/Undo/<Pick
point or point numbers>]: (Pick)
Slope/Ratio/Interpolate/Degree/screen
Pick/<Elevation> <0.00>: 815
Z: 815.00, Hz dist: 26.32, Slope dist:
26.33, Slope: 3.8% Ratio: 26.3:1
[Arc/Close/Direction/Extend/Follow/Undo/<Pick
point or point numbers>]: (Enter)
Pull-Down Menu Location: Tools->Surface Tools
Prerequisite: None
Keyboard Command: 3dbase